One shortcoming of hardwood flooring in Manitoba is that it wears off with time. Although it may last for a long duration of time, but it is essential to carry out hardwood restoration in Winnipeg so as to maintain the look of the hardwood. The wearing off would be very visible on hardwood floors located in parts of the house with foot traffic.
When the hardwood become dilapidated, they would become unpleasant to the eye and would be very difficult to clean. Hardwood restoration in Winnipeg is appropriate in such situation to brighten and also chip away the dirty materials which are preventing the outer layer of the hardwood. This means that preserving the luster as well as the beauty of a floor depends on periodic maintenance as well as hardwood floor refinishing in Winnipeg.
It is also essential to note that all the dullness which is chipped away would require hardwood restoration in Winnipeg to look perfect. In some cases, all you need is plain old water and clothes to shine on your wooden floor so as to bring back the beauty. The lucky part is that there are ways by which you can check whether it is time for you to mop or start moving your furniture and get started. The first thing involves looking at the hardwood floor which is mostly used, then drench the part with water, maybe a tablespoon or two. Then observe the change.
If the water immediately forms into small beads, this implies that the protective polished used for the hardwood installation Manitoba is still working and a full scale refinishing is not needed. All that would be needed in such scenario is a wipe with a wet cloth or a stain remover but if the water percolated into the floor has caused it to become darker in color, the coating is already ruined and hardwood refinishing in Winnipeg would be essential in such situation.
Hardwood floor refinishing in Winnipeg is not a task that can be done by anyone, it is essential to hire the service of professionals who have the right knowledge and have been in the field for a long period of time because it is essential to have a good experience with hardwood so as to deliver an outstanding project. However, if you want to do your hardwood installation in Manitoba yourself, you can go through the steps below.
The first thing is to measure the hardwood floor area which you want to refinish. In most cases, floors which measures less than or equivalent to fifty square feet can be sanded manually. You can then use a sanding paper and a good pair of kneepads to finish the job. On the other hand the area to be finished is very large, it will result to you stressing your joint as well as a knee cap during the process.
The next thing is to take out all the furniture which can obstruct your refinishing work area, strike out the old coating on the floor which are made with varnish, wax or paint. Wax covering can be easily eliminated by making use of wax stripper while vanish or petroleum-based floor lamination can be removed by lacquer or acetone thinner. Once the hardwood coating has been removed, the floor is ready for sanding.
The third step is to ensure you remove the nail and carpet that stick to the floor surface because the nail and tacks would ruin sandpaper, power sander and, may also harm your hand in the process. Once they have been removed, ensure you finish off the holes they left with commercial wood filler of matching color.
After sanding the whole hardwood surface, you should wipe the damp floor with cloth or mop. It is also better if you can get a resin-coated cloth; it can be gotten from the hardware shop and is perfect for taking microscopic dust pieces. The final step involves the application of fresh coating wax, paint or vanishes when the floor has dried.